Comunidad, necesito mucho de su ayuda.

Tengo una pc que va a ser un proxy (Suse 10.3), veo a las dos redes (publica y privada) pero no puedo navegar por nada del mundo :? , pensaba que eran los DNS pero están bien.

Realmente estoy un poquito desesperado :O , agradeceria cualquier ayuda. Esta info es de la PC. Si alguien necesita mas info por favor me avisa.

IFCONFIG
--------

eth0 Link encap:Ethernet HWaddr 00:E0:4C:0B:2B:D9
inet addr:201.xxx.xxx.xxx Bcast:201.xxx.xxx.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:386 errors:0 dropped:0 overruns:0 frame:0
TX packets:29 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:23850 (23.2 Kb) TX bytes:4109 (4.0 Kb)
Interrupt:11 Base address:0x4000

eth1 Link encap:Ethernet HWaddr 00:15:58:C1:EB:DB
inet addr:192.168.71.88 Bcast:192.168.71.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:224 errors:0 dropped:0 overruns:0 frame:0
TX packets:30 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:25406 (24.8 Kb) TX bytes:4277 (4.1 Kb)
Interrupt:10

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:419 errors:0 dropped:0 overruns:0 frame:0
TX packets:419 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:32834 (32.0 Kb) TX bytes:32834 (32.0 Kb)

ROUTE
------
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.71.0 192.168.71.5 255.255.255.0 UG 0 0 0 eth1
201.xxx.xxx.0 201.xxx.xxx.xxx 255.255.255.0 UG 0 0 0 eth0
link-local * 255.255.0.0 U 0 0 0 eth0
loopback * 255.0.0.0 U 0 0 0 lo

HWINFO --NETCARD
-----------------
25: PCI 202.0: 0200 Ethernet controller
[Created at pci.301]
UDI: /org/freedesktop/Hal/devices/pci_10ec_8169
Unique ID: rBUF.oxSyVMMObW1
Parent ID: 6NW+.clCealCK_QA
SysFS ID: /devices/pci0000:00/0000:00:1e.0/0000:02:02.0
SysFS BusID: 0000:02:02.0
Hardware Class: network
Model: "Realtek RTL-8169 Gigabit Ethernet"
Vendor: pci 0x10ec "Realtek Semiconductor Co., Ltd."
Device: pci 0x8169 "RTL-8169 Gigabit Ethernet"
SubVendor: pci 0x10ec "Realtek Semiconductor Co., Ltd."
SubDevice: pci 0x8169
Revision: 0x10
Driver: "r8169"
Driver Modules: "r8169"
Device File: eth0
I/O Ports: 0xee00-0xeeff (rw)
Memory Range: 0xfdbff000-0xfdbff0ff (rw,non-prefetchable)
Memory Range: 0xfda00000-0xfda1ffff (ro,prefetchable,disabled)
IRQ: 11 (423 events)
HW Address: 00:e0:4c:0b:2b:d9
Link detected: yes
Module Alias: "pci:v000010ECd00008169sv000010ECsd00008169bc02sc00i00"
Driver Info #0:
Driver Status: r8169 is active
Driver Activation Cmd: "modprobe r8169"
Config Status: cfg=no, avail=yes, need=no, active=unknown
Attached to: #20 (PCI bridge)

26: PCI 203.0: 0200 Ethernet controller
[Created at pci.301]
UDI: /org/freedesktop/Hal/devices/pci_11ab_4320
Unique ID: JNkJ.rcX7Obi3x12
Parent ID: 6NW+.clCealCK_QA
SysFS ID: /devices/pci0000:00/0000:00:1e.0/0000:02:03.0
SysFS BusID: 0000:02:03.0
Hardware Class: network
Model: "Foxconn International 88E8001 Gigabit Ethernet Controller"
Vendor: pci 0x11ab "Marvell Technology Group Ltd."
Device: pci 0x4320 "88E8001 Gigabit Ethernet Controller"
SubVendor: pci 0x105b "Foxconn International, Inc."
SubDevice: pci 0x0cc5
Revision: 0x14
Driver: "skge"
Driver Modules: "skge"
Device File: eth1
Memory Range: 0xfdbf8000-0xfdbfbfff (rw,non-prefetchable)
I/O Ports: 0xec00-0xecff (rw)
Memory Range: 0xfda20000-0xfda3ffff (ro,prefetchable,disabled)
IRQ: 10 (884 events)
HW Address: 00:15:58:c1:eb:db
Link detected: yes
Module Alias: "pci:v000011ABd00004320sv0000105Bsd00000CC5bc02sc00i00"
Driver Info #0:
Driver Status: sk98lin is active
Driver Activation Cmd: "modprobe sk98lin"
Driver Info #1:
Driver Status: skge is active
Driver Activation Cmd: "modprobe skge"
Config Status: cfg=no, avail=yes, need=no, active=unknown
Attached to: #20 (PCI bridge)